Tolet Macerating Upflush Toilet System

The Tolet Macerating Upflush Toilet System is the definitive solution for adding a bathroom in a basement space utility room or any location below or remote from the existing drain line without breaking concrete cutting floor joists or performing the structural modifications that a conventional gravity drain toilet installation would require. The macerating unit connects directly to the toilet outlet and grinds solid waste and toilet paper into a fine slurry using stainless steel cutting blades rotating at 3600 RPM before pumping the slurry through a 22mm diameter discharge pipe that can run horizontally up to 150 feet or vertically up to 15 feet to reach the existing drain stack. This discharge pipe diameter is small enough to route through wall cavities beneath floorboards and around structural elements that a 4-inch gravity drain pipe could not navigate without major structural intervention. The unit connects to a standard household 110V outlet and activates automatically when the toilet is flushed drawing 1.0 kilowatt-hours per 500 flush cycles – an energy consumption rate that adds less than two dollars per month to a typical household electricity bill. The macerating unit accommodates connection of one toilet one sink one shower and one bathtub simultaneously making it a complete wet room solution rather than a toilet-only system. The sealed stainless steel body resists corrosion from the waste stream and the cutting blades are accessible for replacement through a service panel without moving the unit. A manual override switch bypasses the automatic activation sensor for maintenance and testing purposes.